Estimating Tip: CCC – Rear Body replacement “Rear Compartment Trim (as necessary)”

Recent DEG Inquiry 17218 states when a user sees a footnote "Rear Compartment Trim (as necessary)" is the general description used to describe any "Trim" that directly attaches to the inside of the "Rear Body [...]

2020-11-20T14:41:46-05:00November 23rd, 2020|DEG Estimating Tips|

Estimating Tip: CCC, Mitchell and Audatex- Duplicate R/I and or Fitting operations

Some labor operations in all three estimating systems may included operations which are only accounted for 1 time to be done in the labor operation. If duplicate r/I or fitting operations are done, this would [...]

2020-11-16T09:57:54-05:00November 16th, 2020|DEG Estimating Tips|

Estimating Tip: Mitchell – Checking and filling Transmission Fluid (ATF)

Inquiry 17115 identified that Checking and Filling ATF is not factored into the Radiator labor time. Additional labor for Checking, Filling and Fluid cost is NOT included and would be an on the spot evaluation. [...]

2020-11-09T10:10:07-05:00November 9th, 2020|DEG Estimating Tips|

Estimating Tip: Audatex – Tesla Model 3 HV Battery disable

Recent DEG Inquiry 16931 for Audatex has updated the Model 3 HV Battery disable labor and provided feedback about the operation. Some vehicle repairs may require multiple duplicated procedures throughout various repair stages. “We have [...]

2020-11-02T10:10:02-05:00November 2nd, 2020|DEG Estimating Tips|

Estimating Tip: CCC – F-150 “Bed Set Back” no longer listed.

Recent DEG Inquiry 17032 “Estimated Release Date: Closed Proposed Resolution: MOTOR stated: After review of the procedural steps for "Set Back Box Assembly" vs "R&I Box Assembly" the same procedural steps are required for both [...]

2020-10-26T09:52:40-04:00October 26th, 2020|DEG Estimating Tips|

Estimating Tip: Mitchell – Labor for Destructive Weld Testing

Recent updates to Mitchell MCE and ULTRAMATE program will now display “Labor for Destructive Testing as NOT INCLUDED. Mitchell users can find this operation located in the “Ref Sheet>> Additional Operations>> Welding>> Destructive Weld Testing” [...]

2020-10-16T11:21:31-04:00October 19th, 2020|DEG Estimating Tips|

Estimating Tip: CCC – Trimming braces molded into bumpers.

Some replacement parts may be shipped with support bracing that would need to be trimmed away before installing on the car. Any modifications to the component requiring trimming of unneeded bracing would be NOT INCLUDED. [...]

2020-10-09T15:44:22-04:00October 12th, 2020|DEG Estimating Tips|

Estimating Tip: CCC, Mitchell and Audatex: Rivnut, Rivstud, Nutsert and misc Attachment Hardware.

Some replacement panels may require additional mounting hardware for attached components. The labor and hardware cost to install these misc. fasteners to the replaced panel are NOT INCLUDED unless specified in the footnotes in the [...]

2020-09-28T10:03:44-04:00September 28th, 2020|DEG Estimating Tips|
Go to Top