Estimating Tip – Mitchell – Matte Clear Coat
DEG Inquiry 23038 confirms operations outside of normal gloss clear coat steps are NOT INCLUDED: "The Matte Clear application process may vary by paint manufacturer, and situations can exist where the application requires additional steps outside the procedure inclusions. Commonly, performing spray-out cards or "let-down" panels for matching a matte sheen or finish may be necessary. When conditions arise outside the procedure inclusions, additional considerations should be handled on a [...]
Estimating Tip – Solera Qapter (Audatex) – Estimate Totals Quick View
Solera Qapter users can quickly review "Estimate Totals" without having to preview the entire estimate. Step 1: Click on the down arrow next to the [...]
Estimating Tip – CCC – Assigning component classification designation
CCC Users can quickly assign Mechanical (M) or Structural (S) rate classifications to the replacement parts by following these steps: 1. Right Click on the [...]
Estimating Tip – Mitchell – Disable & Enable Airbag System
DEG Inquiry 17882 confirms what steps are considered during "Disable & Enable Air Bag System."According to Mitchell Cloud Estimating, "the labor allowance for Disable & Enable [...]
Estimating Tip – Solera Qapter (Audatex) – Additional Labor Operations
When performing R&R (Remove and Replace) or R&I (Remove and Install) procedures in Solera Qapter, users can quickly include necessary "Additional Labor Operations" directly during [...]
Estimating Tip – All Three – Solvent Testing Replacement Parts
Replacement parts may require solvent compatibility testing prior to refinishing to ensure your products don’t react with factory coatings. Labor and materials to test, strip, [...]
Estimating Tip – Solera Qapter (Audatex) – Attachment Photo Mark-Up
Use the integrated markup tools to highlight specific damage or repair areas directly on your photos. When you save these annotations, Qapter automatically preserves the [...]
Estimating Tip – Mitchell – Masking Backside of Bumpers
DEG Inquiry 40336 confirms published refinish times on bumpers may not include masking the backside of bumper in the radar zone. Where we have been able [...]
Estimating Tip – Solera Qapter (Audatex) – Chip Guard Application
Solera Qapter users can reference information about Chipguard application in Solera DBRM page 139 section 4-4 Refinish Guidelines "The application of chipguard material to the lower [...]
Estimating Tip – CCC – Filling and Bleeding Cooling Systems
DEG Inquiry 40223 addresses feedback from MOTOR about operations that are NOT INCLUDED when filling and bleeding cooling systems"1. According to the "Guide To Estimating: RADIATOR", [...]