Refinish Overlap does not apply to a component refinished during a procedure separate from the main component. This situation is covered in the “Guide To Estimating: Panel and Component Designation, Individual Procedure Items/Areas” as follows, “Areas of a panel or component that are part of a main component, but are refinished during a procedure separate from the main component. Example: edges, jambs, hinges, inside panels and the underside of hoods, deck lids, liftgates, etc.

No overlap deduction should be taken when calculating refinish time for items from this category.”

Please note:

The Estimating system is not able to determine if the Part is a different color or if it’s refinished during a procedure separate from the main component.

  • This will require a manual deletion of the “Refinish Overlap” if the Part is a different color or if it’s refinished during a procedure separate from the main component.
  • A combination of items from this category refinished during a single, continuous procedure should be subject to the appropriate “Adjacent” or “Non-Adjacent” overlap formula deduction.

The older Subaru Outback is example where the bumper cover is a separate color from the vehicle.

The estimating databases are all intended to be used as a GUIDE ONLY – it is important to remember that the auto body professional performing the repair is in a position to thoroughly inspect, diagnose and identify the methodology and their unique cost of the vehicle damage repair.

You can view this tip and others on the DEG website by clicking here!

For more information about SCRS, or to join as a member, please visit
www.scrs.com, call toll free 1-877-841-0660 or email us at info@scrs.com.